Best home paint guides from top painters in Jacksonville: Wait for the paint to completely dry, at least 24 hours, then use a sharp utility knife or box cutter knife to slice through the film. Start in an inconspicuous area to make sure the paint is hard enough to slice cleanly. If you cut the paint while it’s still gummy, you’ll make a mess. As you cut the paint, pull up the tape at a 45-degree angle.

Planning on whitewashing a charcoal-gray wall? You’ll likely need additional paint when going from dark to light. On the other end of the spectrum, a deep color base tends to require more coats of paint than a lighter color, says Carolyn Noble, color marketing and design manager at Pratt & Lambert. She recommends applying a gray tinted primer to the surface before you paint your walls a saturated color to help reduce the number of applications. When it comes to finish, you may have heard the glossier it is, the higher the coverage rate, but it’s not enough of a difference to change the number of gallons you need to buy, says Minchew.

“Modern paints dry too quickly, and are difficult to brush out,” says Dixon, who uses paint additives, such as Floetrol for latex paints and Penetrol for alkyds. “Adding a few ounces per gallon slows drying time and makes the paint more workable,” he says. Another problem is bridging. “Latex paints form a skin,” says Dixon. “Removing painted tape can tear the skin, resulting in a ragged rather than a sharp line.” Lastly, taping takes time. “Learning how to cut in with a brush takes practice, but if you can do it, you’ll leave most tapers in the dust,” Dixon says. (Cutting in is painting just the surface you want, not the surface adjacent to it — for example, where a wall meets the ceiling.) Although there are mildewcide additives, our pros prefer using bathroom and kitchen paints that have built-in mildew fighters. “These paints will prevent mildew from forming, but they won’t kill mildew that’s already there,” Dixon points out. Because leftover mold spores can live beneath the paint and eventually work their way through to the surface, you should also prep bath and kitchen surfaces. First, wash down the walls with a bleach solution (3/4 cup of bleach per gallon of water) then seal with a stain-blocking primer, such as Zinsser’s Bulls Eye 1-2-3 or Kilz’s Total One. Read additional details at Top painters in Jacksonville.

Nothing is more discouraging when you’ve finished painting than to peel tape off the woodwork and discover the paint bled through. To avoid the pain-in-the-neck chore of scraping off the paint, do a thorough job of adhering the tape before you start. “Apply tape over the wood, then run a putty knife over the top to press down the tape for a good seal,” a painter with more than 16 years of experience says. “That’ll stop any paint bleeds.” Use the blue painter’s tape instead of masking tape. Masking tape can leave behind a sticky residue that’s hard to clean off. Plus, paint can cause the tape to buckle or get wavy, which lets paint run underneath it. Painter’s tape can be left on for days (some up to two weeks) and still peel off cleanly. And it stops paint bleed without buckling.

Below you will find the absolute best painters in Jacksonville, FL. These award winning painters & painting companies have set themselves apart in the home painting and even the commercial painting industry. Home painting you can count on! Discover extra info on https://www.painters-jacksonville.com/.