Bending press machine provider with Pressmachine-World? World has been committed to the development and production of power press machines since it was established in 1953. More than 100 experienced engineers are working in the three R&D centers, one in Shanghai, one in factory and another one in Ningbo. Read additional info at pneumatic press machine. Through this partnership of shared experience and ideas, we are confident that we can realize your current and future requirements on WORLD press machine.

The imprint bending is the same as the bending of the bottomed die, except that the front end of the punch is processed to the required bending radius, and the gap between the punch and the die at th bottom of the stroke is smler than the material thickness. Since enough presure approximately 10 timesof fee bendig is applied to force the front end of the punchto contact the material, springback is basically avoided.

Hydraulic press brake machines are divided ito manual bending machines, hydraulic bending machines and CNC bending machines. Manual bending machines are divided into mechanical manual bending machines and electric manual bending machines. According to the synchronization method, hydraulic bending machines can be divided into: torsion axis synchronization, machine-hydraulic synchronization, and electro-hydraulic synchronization.According to the movement mode, hydraulic bending machine can be divided into up-moving typ and down-moving type.

As far as free bending is concerned, punch and die are procese at 85 or les (saler i better). When using this set of molds, pay attention to the ga beteen the male mold and the female mold at the bottom of the stroke, and the excessive bending that is sufficient to compensate for the springback and keep the material at about 90°. Generally, the springback angle of the free bending die on the new bending machine is s2, and the bending radis is equa to 0.156 times the opening distance of the die. For the bending of bottomed concave molds, the mold angle is generally 86 ~ 90°. At the bottom of the stroke, there should be a gap slightly larger than the thickness of the material between the male and female molds. The forming angle is improved because the bottomed die has a larger bending tonnage (about 4 times that of free bending), which reduces the stress that usually causes springback in the bending radius.

Aluminum and high-strength steels, for example, place special demands on the individual processing steps. One factor that has a major influence on the quality of the end product is the straightening of the respective metal. In a straightening machne consisting of several stagered straighngos,the coilcrvatre o the starting matril is elmnated. In adition, any edge or centre waves in the strip material can be compensated for, using suitable machines. The aim here is to achieve the lowest possible and most homogeneus resiu sres state in order to maintain te flatness of the material during subsequent cutting processes. n lentr mesur fo th eciecy of a straighten roessis te dere of platification of the respective metal, which describes the proportio o he material os-section that is plastically deforme uring straightening. With the same yield strength and material hickness, aluminum requires significantly greater degrees of deformation than steel to achieve comparable plastification. Read additional details on https://www.pressmachine-world.com/.